• +0086-371-86162511
  • Zhengzhou, China

Replacement Of Sand By Marble Powder In Ncrete

Stay Touch
With Us
Information Request

News & Detail

  • Replacement Of Sand By Marble Powder In Concrete

    Research Paper PARTIAL REPLACEMENT OF CEMENT WITH MARBLE DUST POWDER Prof. P.A. Shirule a*, Table 3: Sand Marble powder: Marble powder was collected from the dressing and processing unit in Jalgaon. It was initially in wet form (i.e. slurry); after that it is dried by exposing in the sun and finally sieved by IS-90 micron sieve before mixing in concrete.

  • Experimental Study On Concrete Using Waste Marble powder,

    of using marble powder waste as partial replacement of fine aggregate in concrete. Since this concrete is prepared with marble powder as a partial replacement of fine aggregate (Sand) in four different proportions i.e. 10%, 15 % ,20% and 25 % and tested for the period of

  • THE EFFECTS OF REPLACEMENT OF CEMENT AND SAND IN

    Replacement of sand by marble powder from 5-20% , in concrete production, results in similar and mostly enhanced performance than the control concrete specimens; with slightl increase in compressive strength and slight slump improvement in both mixes.

  • replacement of sand by marble powder in concrete - BINQ

    Replacement of sand by marble waste powder from 5-20% ranges, in concrete production, results in similar and mostly enhanced performance than the control » More detailed Influence of Marble Powder Mortar and Concrete Mix – NBM&CW

  • Use of Waste Marble Powder as Partial Replacement in,

    It can be noted that the split tensile strength for concrete mix increased with 8.7% when partially replaced by 10% marble powder dust against cement and also increased by 9.3% as in the partial replacement with sand having 10% marble dust powder.

  • EXPERIMENTAL INVESTIGATION OF PARTIAL REPLACEMENT OF,

    BabooRai, Khan Naushad (2011) studied the influence of marble powder in cement concrete mix. In this paper the effect of use of marble powder and granules has been studied by partially replacing with mortar and concrete constituents. And check the different properties like relative workability and compressive and flexure strengths.

  • Properties of concrete incorporating sand and cement with,

    replacement of cement or sand by marble powder for improvement in concrete properties. It shows that sand replacement gives better results as compare to cement replacement. Givi et al. (2010) studied that average particle size of rice husk provides positive effect on compressive strength and water permeability of hardened concrete.

  • THE EFFECTS OF REPLACEMENT OF CEMENT AND SAND IN

    Replacement of sand by marble powder from 5-20% , in concrete production, results in similar and mostly enhanced performance than the control concrete specimens; with slightl increase in compressive strength and slight slump improvement in both mixes.

  • IJERT-Use of Waste Marble Powder as Partial

    The properties of a concrete mix if varying marble powder dust is main objective of this study is to develop useful concrete mixes partially replaced in the concrete mix. using waste marble powder as partial replacement of cement and sand. 1.1 Research Significance Keywords: Waste marble powder, concrete, compressive strength, flexure strength,,

  • Marble Powder As A Partial Replacement Of Sand

    V. CONCLUSION From the test results it is clearly evident that granite powder as a partial replacement of sand proves to be beneficial when Durability properties of Concrete is considered. Durability of Concrete using Granite Fines is almost same as that of reference mix (GF0), However at 30% replacement compared to other proportions yielded better durability.

  • EXPERIMENTAL INVESTIGATION OF PARTIAL REPLACEMENT

    BabooRai, Khan Naushad (2011) studied the influence of marble powder in cement concrete mix. In this paper the effect of use of marble powder and granules has been studied by partially replacing with mortar and concrete constituents. And check the different properties like relative workability and compressive and flexure strengths.

  • Replacement of Fine Aggregates by Mixture of Ceramic and,

    insulators and marble chippings as a replacement of fine aggregate in concrete will solve the problem of disposal of wastes as well as will make the construction economical by utilizing waste materials. In order to use ceramic and marble mixture as fine aggregate in concrete these

  • Experimental Utilization of Marble Dust Powder as Partial,

    marble powder as replacement of cement and sand in a mix. The result showed that the workability of a concrete mix was decreases with increase in the powder dust content. • Strength Compressive Strength It can be noted that when cement is partially replaced by the marble powder

  • What are the Materials for Replacement of Sand in

    Granulated blast furnace slag is a waste of steel industry; its use can be best exploited as part replacement of sand in concrete. It can replace sand to the amount of 70 % in concrete mixes. Its Availability is limited, restricted to steel plant area.

  • (PDF) Effect of rice husk ash and marble powder on,

    The concrete samples are produced by replacing sand with marble powder at 10%, 20%, 30%, 40%, 50% and 90% by volume.

  • Properties of Hardened Concrete Produced by Waste

    03-07-2015· Also, The Use Of Marble Dust As Sand Replacement Was More Effective With Lower W/C Ratio. Generally, The 10.0% Marble Dust Content As Sand Replacement Was Considered The Optimum Content That Achieving The Highest Concrete Tensile Strength. This Trend Was The Same For 0.50 And 0.40 W/C Ratio. Aliabdo, Abd Elmoaty,& Auda, 2014.

  • (PDF) Behavior of Concrete Using Marble Waste as

    Utilisation of marble waste as replacement for conventional coarse aggregate in concrete mixes. The huge amount of waste is generated during mining and processing operation.

  • Marble Powder As A Partial Replacement Of Sand

    V. CONCLUSION From the test results it is clearly evident that granite powder as a partial replacement of sand proves to be beneficial when Durability properties of Concrete is considered. Durability of Concrete using Granite Fines is almost same as that of reference mix (GF0), However at 30% replacement compared to other proportions yielded better durability.

  • An Experimental investigation on utilizations of Marble,

    The durability as well as workability has increased to large extent by use of marble dust as replacement of fine aggregate and coarse aggregate. The effect on properties of concrete were investigated and concluded that optimum percentage for replacement of sand with marble powder in

  • Influence of limestone waste as partial replacement,

    ment of sand with limestone waste (LSW), with marble powder (M.P) as an additive on the concrete properties.Thereplacementproportionofsandwithlimestonewaste,25%,50%,and75%wereprac-ticedintheconcretemixesexceptintheconcretemix.Besides,proportionsof5%,10%and15%mar-ble powder were practiced in the concrete mixes.

  • Review on the feasibility of Marble Dust as Replacement of,

    waste marble powder construction industry itself as fine aggregate replacing natural sand in concrete. The replacement is done partially and fully in the proportion 0%, 25%, 50% and 100% and its effect on concrete properties were analyzed and outcomes that replacement of 50% of sand with marble powder is

  • An Experimental Investigation on Mechanical Properties of,

    usage of waste marble powder (WMP) as partial replacement of sand for production of concrete. Keywords –Compressive Strength, Split-tensile Strength, Flexural Strength and Waste Marble Dust (WMD) . I INTRODUCTION Concrete plays an inevitable

  • Experimental Utilization of Marble Dust Powder as Partial,

    marble powder as replacement of cement and sand in a mix. The result showed that the workability of a concrete mix was decreases with increase in the powder dust content. • Strength Compressive Strength It can be noted that when cement is partially replaced by

  • EXPERIMENTAL INVESTIGATION ON CONCRETE USING MARBLE

    Steel slag can be use in the construction industry as aggregate in concrete by replacing natural aggregates.This experimental study is based on the performance of concrete by replacement (5%,10%,15%,20%) of cement with waste marble powder and replacement (10%,20%,30%,40%,50%) of fine aggregate by steel slag.

  • What are the Materials for Replacement of Sand in

    Granulated blast furnace slag is a waste of steel industry; its use can be best exploited as part replacement of sand in concrete. It can replace sand to the amount of 70 % in concrete mixes. Its Availability is limited, restricted to steel plant area.

  • A study of the chemical effect of marble and granite,

    04-02-2020· For sand replacement, and by replacing 10% of sand with marble powder in (NF10), the compressive strength value rises up to 5% above the control CM. Replacing 5% of cement and 10% of sand with marble waste powder in NC5 + NF10 mix gives almost the same compressive strength value obtained from CM.

  • Sustainable use of fly ash and waste marble slurry powder,

    01-01-2020· Ashish et al. studied the use of marble dust in concrete as sand, cement, and cement sand replacement. The result shows that mechanical properties are optimum at 10% replacement of cement. In the case of sand replacement and cement sand amalgam, optimum replacement by marble powder is 15% and 20% respectively.

Quick response, N-CAI Heavy Industry welcomes all sectors of society to contact us, we are waiting for your inquiry within 365x24 hours!